Powerwalker ATS Uživatelský manuál stáhnout pdf (Strana 7)

Contact Ports

The contacts port is formed using six (6) pins numbered from left to right (see fig. 1), which can be

connected to an external monitoring system (such as a BMS) in order to monitor the operational

status of the ATS.

The external equipment must respect the voltage and current characteristics of contacts port.

Fig. 1: Focus on contacts port.

The contacts port provides the following pins:

 Pin 1: common contact.

 Pin 2: “Source B” active contact (if the contact between “pin 1” and “pin 2” is closed, output is

supplied by “Source B”).

 Pin 3: “Source A” active contact (if the contact between “pin 3” and “pin 1” is closed, output is

supplied by “Source A”).

 Pin 4: “Source A” status OK contact (if the contact between “pin 4” and “pin 1” is closed,

“Source A” is present and regular).

 Pin 5: “Source B” status OK contact (if the contact between “pin 5” and “pin 1” is closed,

“Source B” is present and regular).

 Pin 6: Status OK contact (if the contact between “pin 6” and “pin 1” is closed, ATS functioning

status is regular).

The following diagram shows the functioning of the contacts port.

Fig. 2: Contacts port basic diagram.

ATTENTION: The pins of the contact port are able to carry maximum current of 8A and maximum

voltage of 250Vac.

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

Powerwalker ATS Uživatelský manuál Strana 7